Die Cuts and Embossing Folders

Here's a quick card you can make using a few die cuts, a border punch, embossing folder and, of course, a stamp.

HappyBirthday

Begin with an 8-1/2" X 5-1/2" piece of Rose Red card stock.  Score and fold in half to create your card base.

Cut a 4-1/8" X 5-3/8" piece of Early Espresso card stock.  Place it inside the Square Lattice Textured Impressions embossing folder and run it through your Big Shot die cut machine.  Adhere to card base using Tombow Multipurpose Liquid Glue.  Because this layer is so textured, liquid glue is a good choice.

Cut a 2" X 4-1/8" piece of Regal Rose card stock.  Use the Eyelet Border punch along both long sides.  Stamp your verse in the center of this layer using Basic Black ink and adhere to card using the Tombow liquid glue.

The flower was made from small pieces of Regal Rose, Rose Red and Blushing Bride card stock and the Blossom Party Originals die.  You can stack the card stock and die cut all 3 flowers at one time.  Arrange them as shown and adhere together.  The center was made using the 1/2" circle punch and Regal Rose card stock.  If desired, apply Crystal Effects and a light sprinkle of Dazzling Diamonds glitter.  Allow to dry and adhere to center of flower.  Attach to card using Tombow liquid glue or Crystal Effects.

Supplies used:
102544 Rose Red card stock
105130 Regal Rose card stock
119796 Blushing Bride card stock
119686 Early Espresso card stock
101179 Basic Black Classic Stampin' Pad
120510 (C) or 117014 (W) Curly Cute Stamp Set
119976 Square Lattice Embossing Folder
115971 Blossom Party Originals die
113439 Big Shot Die-Cutting Machine
119869 1/2" Circle Punch, small
110755 Tombow Multipurpose Liquid Glue
101055 Crystal Effects
102023 Dazzling Diamonds Stampin' Glitter

If you need any of these supplies, click the shopping tote to easily place your order!

Leave A Comment...

*